Requirements for operating CNδ≥C machining centers

The correct operation and maintenan₽™δce of CNC equipment can preventσ∑∞γ abnormal wear of the machine tΩ®βσool and avoid sudden failure of the m✔φachine tool. Carefulε€ maintenance of the m♦γ÷≈achine can maintain the lo©"ng-term stability of the machine&"↔×↔#39;s machining accuracy and prolong t☆→↕he service life of the machine. CNC par₹₩☆t machining center manufacturers ↓♦εtake this work seriously.

Basic requirements for operating↕φφ© CNC machining centers₩₽:

1. The working temperature of the e☆ε quipment should be controlled betwe★↓en 15 and 35 degrees. T↓"he precision processing t€≥σemperature should be controlled at®‌  about 20 degrees, and ♥→temperature fluctuations should be s ✔ ‍trictly controlled.

2. In order to avoid large power ≠¶≠σfluctuations (greater than or™‍ less than 10%) and possible →∞effects of instantaneous∑ ↓♠ interference signals, CNC equipmen δ≈t is usually powered by ₹>dedicated lines (such as ma☆₹chine tools separated from CNC's lo↓Ω₹w-voltage power distributio<<•♠n room) and voltage regulators. R¥"educe the impact of power quali↔↓ty and electrical interference.€•δ

3. Requires the use of CNC equipme​↓'nt to avoid humid, d♣∑ε↔usty, and non-corrosive places;

4. Avoid direct sunlight and ot ✔γ★her heat radiation. The precision ​©CNC equipment should be far®λ♣β away from the equipment with lar>→±ge vibration, such as punching machineγ©, forging equipment, etc ♦×♥©.;

Person in charge of maintenance:

1. Equipment maintenan ≠ce personnel are responsible for eq±∏✔≈uipment maintenance and necessar₩≥y maintenance;

2. Workshop managemen‌ β"t personnel are responsible foε×εr operator supervision and eqγΩ‍♦uipment maintenance ♦δof the entire workshop.

3, the operator is respo≈→<∑nsible for the use, maintena≠αβnce and basic maintenance of the ×↕Ω↑equipment;

Maintain daily machining accurac₽>&y:

1. Before closing, place the & ↑ table and saddle in the ≤€εcenter of the machine (turn ®<♠ the three-axis stroke to 'γ‍σthe middle position of each§₩∑ axis stroke);

2. The machine tool should  ✔®be kept dry and clean.∞ 

3. After starting, warm up for about ≈•10 minutes before proce↕​®ssing; machines that have not ↕™§been used for a long ↑ <→time should extend the warm-up σ↑ time;

4, check whether the oil circuit is unb∞↑♣locked;

All in all, this is to main±βtain the service life of CNC in™ αtelligent machine tools. I ✘♣hope the introduction of CNC inte ™lligent machine tools will be helpful ♣¶♠to you.